TM 5-6675-324-14
h. Remove E-ring from separation claw(s) and remove separation claw(s) and
spring(s).
Install new separation claw(s)/spring(s) and secure with E-ring.
i.
j. Reinstall mounting plate and secure with screws.
k. Wipe each claw with lens cleaning tissue.
Raise and latch lower discharge section.
1.
Reinstall lower left panel and paper tray.
m.
Lower and latch upper assembly.
n.
Plug in power cord.
o.
Turn power switch to 1 (ON).
p.
3-20.56 Replace S eparation Belt Roller.
MOS: 35E, Special Electronic Devices Repairer
TOOLS: No. 2 Cross Tip Screwdriver
No. 2 Cross Tip Screwdriver, 2 in.
Flat Tip Screwdriver
Grip Ring Pliers
SUPPLIES: Roller
WARNING
Death or serious injury may occur from electrical shock unless power cord
is unplugged before servicing.
Place power switch to O (OFF).
a.
b. Unplug power cord.
Remove upper and lower rear panels and lower front panel.
c.
3-265
