TM 5-6875-324-14
NOTE
Prevent hopper lid from touching platen. Do not push assembly to front.
1.
Slowly lower developing assembly onto its support while pushing rear
side plate.
m.
Reconnect connectors.
n.
Reinstall top right panel.
o.
Refill hopper with new developer in accordance with operating instruc-
tions (paragraph 3-6.2.1).
Return platen to home position.
P"
Plug in power cord.
q.
r. Turn power switch to 1 (ON).
Replace Keypad.
3-20.25
MOS: 35E, Special Electronic Devices Repairer
TOOLS: No. 2 Cross Tip Screwdriver (6 in.)
Grip Ring Pliers
SUPPLIES: Keypad
WARNING
Death or serious injury may occur from electrical shock unless power cord
is unplugged before servicing.
a. Turn power switch to O (OFF).
b. Unplug power cord.
c.
Remove knob from exposure control lever.
3-188
