TM 5-6675-323-14
b. Remove screws and washers holding stainless steel tank and casing
to chassis.
c.
Lift stainless steel tank and casing free. Set aside.
NOTE
Do not disconnect wires to transducer.
d. Tag and disconnect power cord wire and circuit board wire from power
switch.
Press sides of defective power switch and remove from chassis.
e.
P u s h power switch until tabs lock
f. Install new power switch in chassis.
into hole.
Reconnect wires to power switch.
g.
h. Reinstall stainless steel tank and casing. Secure with screws and
washers.
i.
Fill stainless steel tank 1/3 full with water.
P l u g in power cord and turn power on. Check that water surface
j.
agitates.
12-15
