TM 5-6675-323-14
b. Remove screws and washers holding stainless steel tank and casing
to chassis.
c.
Lift stainless steel tank and casing free. Set aside.
NOTE
Do not disconnect wires to transducer.
d . Remove three screws, one nut, and one washer holding circuit board to
chassis.
e.
Disconnect power cord wires from power switch, chassis ground, and
circuit board.
f. Loosen strain relief bushing from chassis and remove defective power
cord.
Install strain relief bushing on new power cord. Insert terminal ends
g.
of cord into chassis.
h.
Fit strain relief bushing into chassis.
i.
Reconnect power cord wire to circuit board, chassis, and power switch.
Reinstall circuit board into chassis and secure with one washer, one
j.
nut, and three screws.
k. Reinstall stainless steel tank and casing. Secure with screws and
washers.
l.
Fill stainless steel tank 1/3 full with water.
m.
P l u g in power cord and turn power on. Check that water surface
agitates.
12-13
