TM 5-6675-323-14
10-6.3 Preparation For Movement.
a.
Place transport case on work surface.
b. Remove two attachment screws on each optical glass.
c.
Place screws in transport case.
d. Pad optical glass and place in case.
e.
Place stereometer in case.
f. Close lid and check that lid latches.
condition that permits use of a stereoscope.
Section III OPERATOR MAINTENANCE
1 0 - 8 . L U B R I C A T I O N I N S T R U C T I O N S . This equipment does not require lubrication.
1 0 - 9 . T R O U B L E S H O O T I N G . There are no operator troubleshooting procedures assigned
for this equipment.
assigned for this equipment.
Section IV ORGANIZATIONAL MAINTENANCE
L U B R I C A T I O N I N S T R U C T I O N S . This equipment does not require lubrication.
10-12.
REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT
(TMDE); AND SUPPORT EQUIPMENT. T h e s e i t e m s a r e n o t r e q u i r e d f o r t h i s e q u i p m e n t .
10-13.1
Checking Unpacked Equipment.
a. Inspect the equipment for damage incurred during shipment. If equipment has
b e e n damaged, report the damage on DD Form 6, Packing Improvement Report.
b. Check the equipment against the packing list to see if the shipment is
complete. Report all discrepancies in accordance with the instructions of DA Pam
738-750.
c.
C h e c k to see whether the equipment has been modified.
