TM 5-6675-323-14
d. Remove cable retaining screw.
e.
M a r k exact position of encoder on inside walls of encoder housing with
scribe.
f. Remove two hex head screws on side of housing.
R e m o v e defective encoder from housing.
g.
h.
Install new encoder in housing.
i.
M a k e sure the new encoder is parallel with the bottom of the housing and
p l a c e d exactly between the marks made on the housing.
Reinstall two hex head screws on side of encoder housing.
j.
Reinstall cable retaining screw.
k. Insert cable in housing.
l.
Reinstall cable bracket. Secure with screw.
m.
Slide encoder housing onto mounting bar of planimeter.
n.
Tighten thumbscrew holding encoder housing on planimeter.
9-144
