TM 5-6675-323-14
(a) Slide idler reel bracket to rear of lower rail. Spindle tip faces
front.
(b) Slide driver bracket on lower rail, crank facing front. Aline front
of bracket with front of rail.
(c) Tighten black knurled locking knobs.
k. Thread film.
(1) Conventional threading.
(a) Extend drive spindles on all drive reel brackets by turning grooved
spindle-retracting knob to upper locked position.
(b) Insert film supply reel between front bracket and center idler
bracket.
Front bracket drive spindle engages key slot on reel.
(c) Loosen black knurled locking knob on center idler bracket. Move
bracket toward film reel, and engage bearing on bracket with center hole in reel.
Adjust position so that film reel is securely held and has very slight end-play.
(d) Tighten black knurled locking knob on center idler bracket.
(e) Install take-up reel at opposite end of table using same procedure.
6-27
