TM 5-6675-322-14
WARNING
Death or serious injury may occur from failure to turn off and padlock
safety switch before repairing molding.
NOTE
A l t e r n a t e l i g h t i n g i s r e q u i r e d t o p e r f o r m t h i s t a s k .
a.
Turn off and padlock safety switch.
b. Remove conduit cover.
c .
Inspect wires for damage.
NOTE
Refer to direct support maintenance for wiring repair if necessary.
d.
Loosen wiring and carefully pull it from the entire base section.
e .
Remove screws and base from wall.
f. Mark and measure damaged area on molding, Record measurement.
g .
Cut damaged area from molding.
h.
Cut section from new molding to the length recorded in step f.
i .
Using damaged area as a template, mark mounting holes on new piece.
j .
With a number 25 drill bit, drill holes in new molding.
k . W i t h f i l e , r e m o v e a l l b u r r e d e d g e s .
l .
Paint base section as required.
m.
Reinstall conduit base on wall with screws .
n.
Carefully place wiring back in conduit base .
o.
Reins
p.
Test
conti
q.
Test
tall cover on base.
wiring for continuity between power wires and conduit.
I f t h e r e is
nuity, determine and correct grounding fault.
wiring with power on.
1-74
