TM 5-6675-321-14
Section III OPERATOR MAINTENANCE
8-8. LUBRICATION INSTRUCTIONS. This equipment does not require lubrication.
8-9. TROUBLESHOOTING PROCEDURES.
a.
The table lists the common malfunctions which you may find during the
operator maintenance of the support equipment. You should perform the
t e s t / i n s p e c t i o n a n d c o r r e c t i v e a c t i o n s i n t h e o r d e r l i s t e d.
b. This manual cannot list all the possible malfunctions or every possible
t e s t / i n s p e c t i o n a n d c o r r e c t i v e a c t i o n . I f a m a l f u n c t i o n i s n o t l i s t e d o r i s n o t
c o r r e c t e d b y a l i s t e d c o r r e c t i v e a c t i o n , n o t i f y y o u r s u p e r v i s o r .
Table 8-2.
TROUBLESHOOTING
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1.
MAGNIFIER LAMP WILL NOT LIGHT.
Check that magnifier lamp is plugged into active power outlet. Press
switch OFF, then ON.
(a) If lamp still does not come on, replace lamp.
(b) If new lamp does not light, refer to organizational
maintenance.
8-10. MAINTENANCE PROCEDURES.
This section contains instructions covering operator maintenance functions
for the support items. Personnel required are listed only if the task requires more
than one.
b. After completing each maintenance procedure, perform operational check to be
sure that equipment is properly functioning.
INDEX
PROCEDURE
PARAGRAPH
Replace Lamp in Magnifier Lamp Assembly . . . . . . . . . . . . . . . . 8-10.1
8-15
a .
