TM 5-6675-321-14
p.
Reinstall cover plate on top of motor .
q.
Slide main drive gear on shaft and insert roll pin.
r .
Loosen screws and reinstall drive belt .
Tighten screws.
CAUTION
Do not tighten belt so tight that sudden stop by one of gears will stretch
or snap belt.
s.
Slide motor away from secondary gear with one hand until belt is taut.
Tighten one mounting screw.
t .
Check belt for tightness by trying to turn main gear while turning
secondary gear.
u.
I f b e l t s l i p s o v e r t e e t h , i t i s t o o l o o s e . R e p e a t s t e p s .
v .
Tighten remaining motor mounting screws.
w.
R e i n s t a l l r i g h t s i d e p a n e l.
x .
R e i n s t a l l i n n e r p a n e l.
y .
Reinstall top deck cover and top roller cover.
4-20.2 Replace Capacitor.
MOS: 83FJ6, Reproduction Equipment Repairer
TOOLS:
Flat Tip Screwdriver
SUPPLIES:
47 MFD Capacitor (120 V)
I n s u l a t i o n S l e e v i n g
WARNING
• Serious injury may occur if internal components are touched when heat
is on .
Remove heat source and allow to cool, or wear protective
c l o t h i n g b e f o r e s e r v i c i n g.
• Death or serious injury may occur from electrical shock unless power
cord is unplugged before servicing.
a.
Unplug power cord.
b. Remove top deck cover and top roller cover.
4-52
