TM 5-6675-321-14
e.
Install new fluorescent lamp by inserting prongs in holes in spring-
loaded socket. Push fluorescent lamp toward socket until prongs at
other end are alined with holes in larger socket. Release pressure to
seat fluorescent lamp.
f . R e i n s t a l l v i e w i n g s u r f a c e.
g.
Plug in power cord.
h.
Turn power switch ON.
Section IV ORGANIZATIONAL MAINTENANCE
3-11.
LUBRICATION INSTRUCTIONS.
This equipment does not require lubrication
at this maintenance level.
3-12. REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC
EQUIPMENT (TMDE); AND SUPPORT EQUIPMENT.
3-12.1 Common Tools and Equipment. For authorized common tools and equipment,
refer to the Modified Table of Organization and Equipment (MTOE) applicable to your
u n i t .
3-12.2 Special Tools; Test, Measurement, and Diagnostic Equipment; and Support
Equipment.
Special Tools, TMDE, and Support Equipment is listed in the applicable
repair parts and special tools list and in Appendix B of this manual .
3 - 1 2 . 3 R e p a i r P a r t s .
Repair parts are listed and illustrated in the Repair Parts
and Special Tools List, TM 5-6675-314-24P covering organizational maintenance for
this equipment.
3-13. SERVICE UPON RECEIPT.
3-13.1 Checking Unpacked Equipment.
a. Inspect the equipment for damage incurred during shipment. If equipment has
been damaged, report the damage on DD Form 6, Packing Improvement Report.
b.
Check the equipment against the packing list to see if the shipment is
complete. Report all discrepancies in accordance with the instructions of DA Pam
738-750.
c.
Check to see whether the equipment has been modified.
3-14
