TM 5-6675-320-14
e .
Remove four motor mounting screws and carefully remove motor and
b r a c k e t .
f. Detach defective motor from motor bracket by removing nuts, bolts, and
washers holding motor to its bracket.
g.
Install new motor on mounting bracket and secure with bolts, washers,
and nuts.
h.
Install new motor and bracket on plotter and secure with four screws.
i .
Reconnect cable assemblies to A2.
j .
Tighten drive pulley clamping screw.
k. Verify cable tension by performing respective (X- or Y-) cable ten-
sion adjustment procedure (paragraph 4-29.3).
l .
Perform motor driver adjustments (paragraphs 4-29.5, 4-29.6).
m.
Lower upper deck assembly and reinstall rear hood.
4-289
