TM 5-6675-320-14
Table 4-21. PLOTTER OPERATION AND PROGRAM ERRORS - Cont
E r r o r
Error No.
Displayed
Explanation
PLOTTER ROM ERRORS - Cont
P7
axe, ltr INSTRUCTIONS EXECUTED
Occurs on axe and ltr instructions because ROM recognizes
these instructions but cannot execute them. This error flags
all axe and ltr i n s t r u c t i o n s f o r p u r p o s e o f c o n v e r t i n g 9 8 25
programs.
P8
p0
p1
p2
p3
p4
CALCULATOR STOP KEY CANCELLED OPERATION
Occurs on any instruction when plotter fails to respond for
three seconds after STOP key has been pressed. This error is
most likely to occur when pen is traveling slowly.
TRANSMISSION ERROR
Computer has received an illegal ASCII input from plotter.
INSTRUCTION NOT RECOGNIZED
Plotter has received illegal character sequence.
WRONG NUMBER OF PARAMETERS
Too many or too few parameters have been sent with instruc-
t i o n .
BAD PARAMETER
Parameters sent to plotter with instruction are out of range
f o r t h a t i n s t r u c t i o n .
ILLEGAL CHARACTER
Character specified as parameter is not in allowable set for
t h a t i n s t r u c t i o n.
4-212
