TM 5-6675-320-14
Table 4-20. PLOTTER PROGRAMMING LANGUAGE - Cont
Statement Identification and Use
Program
Statement
Statement, Syntax, Explanation, and Input Instructions
wrt - Cont
wrt 705, “CS ( Ø - 4 )”
Character sets command designates one of five sets (Ø-4) as
standard character set. This character set will be used for
all labeling and lettering operations. Character set Ø is
a u t o m a t i c a l l y s e t w h e n e v e r p l o t t e r i s i n i t i a l i z e d.
NOTE
P l o t t e r , w h e n i n i t i a l i z e d , a u t o m a t i c a l l y s p e c i-
fies ANSI-ASCII character set (set Ø) as both
“ s t a n d a r d ” a n d “ a l t e r n a t e ” s e t s . T h e p c l r
statement, however, designates 9825 character
set (set 1) as standard set and set Ø as alter-
nate set. Following keys are used to switch from
standard character set to alternate set and back:
Select standard set = SHIFT F2
Select alternate set = SHIFT F3
Shown below are characters contained in set Ø.
These characters correspond to those on computer
keyboard. They are shown in order (from left to
r i g h t ) o f d e c i m a l - e q u i v a l e n t v a l u e o f t h e i r A S C I I
codes (32-126).
Shown next are symbols in various character sets
that are changed from set, Ø. The plotter will perform
an automatic backspace before drawing any of the
shaded symbols.
4-207
