TM 5-6675-320-14e.Install new fluorescent lamp by inserting prongs in holes in spring-loaded socket.Push fluorescent lamp toward socket until prongs atother end are alined with holes in larger socket. Release pressure toseat fluorescent lamp .f . R e i n s t a l l v i e w i n g s u r f a c e .g.Plug in power cord.h. Turn power switch ON.Section IV2-11. LUBRICATION INSTRUCTIONS.at this maintenance level .ORGANIZATIONAL MAINTENANCEThis equipment does not require lubrication2-12. REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT(TMDE); AND SUPPORT EQUIPMENT.2-12.1Common Tools and Equipment.For authorized common tools and equipment,refer to the Modified Table of Organization and Equipment (MTOE) applicable to youru n i t .2-12.2Special Tools; Test, Measurement, and Diagnostic Equipment; and SupportEquipment. Special Tools, TMDE, and Support Equipment is listed in the applicablerepair parts and special tools list and in Appendix B of this manual.2 - 1 2 . 3 R e p a i r P a r t s .Repair parts are listed and illustrated in the Repair Partsand Special Tools List, TM 5-6675-320-24P covering organizational maintenance forthis equipment.2-13. SERVICE UPON RECEIPT.2-13.1C h e c k i n g U n p a c k e dInspect the equipment for damage incurred during shipment. If equipment hasbeeen damaged, report the damage on DD Form 6, Packing Improvement Report.b. Check the equipment against the packing list to see if the shipment iscomplete.Report all discrepancies in accordance with the instructions of DA Pam738-750.c .Check to see whether the equipment has been modified.2-14a .
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
