TM 5-6675-319-14
Table 1-4. ORGANIZATIONAL TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
4.
NO POWER TO EQUIPMENT - Cont
Step 2.
Check circuit breaker input for 120 V ac.
( a ) I f i n p u t v o l t a g e i s p r e s e n t , p r o c e e d t o s t e p 3.
( b ) I f i n p u t v o l t a g e i s n o t p r e s e n t , r e f e r t o d i r e c t / g e n e r a l
support maintenance for repair or replacement of defective
w i r i n g .
Step 3.
Check circuit breaker output for 120 V ac.
( a ) I f o u t p u t v o l t a g e i s p r e s e n t , p r o c e e d t o s t e p 4 .
( b ) I f o u t p u t v o l t a g e i s n o t p r e s e n t , r e f e r t o d i r e c t / g e n e r al
support maintenance for circuit breaker replacement
(paragraph 1 - 20 . 5).
Step 4.
Remove receptacle and check for 120 V ac input.
( a ) I f p r e s e n t ,
replace receptacle (paragraph 1 - 16 . 6).
( b ) I f n o t p r e s e n t,
refer to direct/general support maintenance
for repair or replacement of defective wiring.
1-16.
MAINTENANCE PROCEDURES.
This section contains instructions covering organizational maintenance
f u n c t i o n s f o r t h e R e c t i f i e r I S e c t i o n .
Personnel required are listed only if the
task requires more than one.
b.
After completing each maintenance procedure, perform operational check to be
sure that equipment is properly functioning.
1-61
a.
