TM 5-6675-319-14
NOTE
Opposite end of shaft must be held while removing nut.
b. Remove drag brake by slowly removing nut on end of shaft.
c .
Remove spring retainer, spring, pressure drag plate, and friction drag
p l a t e.
d. Remove clutch drag plate by removing screws and key washers.
e.
Remove shaft, flat washer, and screws from bearing housing.
f. After bearing housing is removed, remove bronze bushings.
g .
Replace defective parts.
h . R e i n s t a l l b r o n z e b u s h i n g s .
i .
Reassemble shaft assembly by reinstalling flat washer onto shaft and
screws into bearing housing.
j . R e i n s t a l l c l u t c h d r a g p l a t e a n d s c r e w s .
k. Assemble drag brake assembly by installing new friction drag brake,
p r e s s u r e d r a g p l a t e , s p r i n g , s p r i n g r e t a i n e r , a n d s e l f - l o c k i n g n u t.
l .
Reinstall drag brake cover .
9-143