TM 5-6675-319-14
(5) Install new resistor and reconnect wiring.
(6) Reinstall cover.
(7) Turn on circuit breaker.
(8) Turn on MASTER POWER switch.
e .
Replace capacitor.
(1) Turn off MASTER POWER switch.
(2) Turn off circuit breaker.
(3) Remove screws and cover.
WARNING
Ground and discharge capacitor before cutting capacitor leads.
Personal injury may occur from failure to do so.
(4) Using insulated screwdriver, ground capacitor by touching screw -
driver shaft against housing post 8 and machine frame.
(5) Cut defective capacitor lead wires as close to terminal as
possible.
(6) Connect new capacitor lead wires to terminal posts 7 and 8.
9-98
