ah.
Reinstall power cable clamp on lamphouse assembly and place power
cable forward of the blower motor.
a i .
R e i n s t a l l t h e c o l l a r ( o n t h e u n i v e r s a l j o i n t ) o n t h e Y - d r i v e s c r e w a n d —
t i g h t e n t h e c o l l a r s c r e w.
a j .
Loosen Y-drive clamp and X-drive locks.
ak.
Move swing drive knob to the left and move swing drive to zero and
l o c k i n p l a c e .
a l .
Rotate Y-knob and X-knob until lamphouse is at 100 mm on Y-axis and
zero on X-axis.
am.
Reconnect blower duct to lamphouse and blower motor.
an.
R e i n s t a l l b e l l o w s.
ao.
Reconnect power cord.
ap.
Check zero position of film stage (paragraph 7-6.2).
7-10.5 Replace pressure Plate .
MOS :
81C, Cartographer
TOOLS:
Flat Tip Screwdriver
Hex Head Key Wrench Set
SUPPLIES:
Pressure Plate
Lens Cleaner (Item 6, Appendix E)
Lens Tissue (Item 17, Appendix E)
WARNING
Death or serious injury may occur from electrical shock unless power cord
is unplugged before servicing .
a.
Remove dust cover.
7-110
T M 5 - 6 6 7 5 - 3 1 9 - 14
