TM 5-6675-319-14
Section IV ORGANIZATIONAL MAINTENANCE
6-11.
LUBRICATION INSTRUCTIONS. This equipment does not require lubrication.
6-12.
REPAIR PARTS, SPECIAL TOOLS: TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT
(TMDE); AND SUPPORT EQUIPMENT.
6-12.1
Common Tools and Equipment.
For authorized common tools and equipment,
refer to the Modified Table of Organization and Equipment (MTOE) applicable to your
u n i t .
6-12.2 Special Tools: Test. Measurement, and Diagnostic Equipment and Support
Equipment.
Special Tools, TMDE, and Support Equipment is listed in the applicable
repair parts and special tools list and in Appendix B of this manual.
6 - 1 2 . 3 R e p a i r P a r t s.
Repair parts are listed and illustrated in the Repair Parts
and Special Tools list, TM 5-6675-319-24P covering organizational maintenance for
this equipment.
6-13.
SERVICE UPON RECEIPT.
6-13.1 Checking Unpacked Equipment.
a. Inspect the equipment for damage incurred during shipment. If equipment has
been damaged, report the damage on DD Form 6, Packing Improvement Report.
b. Check the equipment against the packing list to see if the shipment is
complete.
Report all discrepancies in accordance with the instructions of DA Pam
738-750.
c .
6-14.
organi
6-15.
troubl
6-16.
t i o ns
Check to see whether the equipment has been modified.
ORGANIZATIONAL PREVENTIVE MAINTENANCE CHECKS AND SERVICES. There are no
zational PMCS procedures assigned for this equipment.
ORGANIZATIONAL TROUBLESHOOTING PROCEDURES. There are no organizational
eshooting procedures assigned for this equipment.
ORGANIZATIONAL MAINTENANCE PROCEDURES.
This
section
contains
instructions
covering
organizational
maintenance
func-
f o r t h e p o r t a b l e t r a c i n g / s c r i b i n g b o a r d .
Personnel required are listed only
if the task requires more than one.
b. After completing each maintenance procedure, perform operational check to be
sure that equipment is properly functioning.
NOTE
The maintenance procedures for the portable tracing/scribing board
c o n s i s t o f r e p l a c i n g t h r e e d i f f e r e n t e l e c t r i c a l c o m p o n e n t s . A
multimeter is needed to determine which component is defective and
needs replacement.
6-15
a .
