TM 5-6675-319-14
Section IV ORGANIZATIONAL MAINTENANCE
5-11 .
LUBRICATION INSTRUCTIONS. This equipment does not require lubrication.
5-12. REPAIR PARTS, SPECIAL TOOLS: TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT
(TMDE); AND SUPPORT EQUIPMENT.
5-12.1 Common Tools and E quipment.
For authorized common tools and equipment,
refer to the Modified Table of Organization and Equipment (MTOE) applicable to your
u n i t .
5-12.2 Special Tools: Test. Measurement. and Diagnostic
Equipment; and Support
Equipment.
Special Tools, TMDE, and Support Equipment is listed in the applicable
repair parts and special tools list and in Appendix B of this manual.
5 - 1 2 . 3 R e p a i r P a r t s.
Repair parts are listed and illustrated in the Repair Parts
and Special Tools List, TM 5-6675-319-24P covering organizational maintenance for
this equipment.
5-13.
SERVICE UPON RECEIPT.
5-13.1 Checking Unpacked Eq uipment.
a. Inspect the equipment for damage incurred during shipment. If equipment has
been damaged, report the damage on DD Form 6, Packing Improvement Report.
b. Check the equipment against the packing list to see if the shipment is
complete.
Report all discrepancies in accordance with the instructions of DA Pam
738-750.
c .
Check to see whether the equipment has been modified.
5-14. ORGANIZATIONAL PREVENTIVE MAINTENANCE CHECKS AND SERVICES.
a.
PMCS are designed to keep the equipment in good working condition by
performing certain tests, inspections, and services .
The intervals provide you, the
organizational technician, with time schedules that determine when to perform
s p e c i f i e d t a s k s.
b. Item number column.
Item numbers are assigned in chronological ascending
sequence regardless of interval designation.
These numbers are used for your “TM
Number” column on DA Form 2404, Equipment Inspection and Maintenance Worksheet, in
recording the results of PMCS.
c . I n t e r v a l c o l u m n s .
This column determines the time period designated to
perform your PMCS.
d. Item to be inspected and procedures column. This column lists functional
groups and their respective assemblies and subassemblies as shown in the Maintenance
Allocation Chart (Appendix B).
The appropriate check or service procedure follows
the specific item to be inspected.
5-15
