TM 5-6675-319-14
5-6. OPERATION UNDER USUAL CONDITIONS.
5-6.1 Assemblv and Preparation For Use.
a.
Release securing strap.
b. Pull bottom out and upward.
c .
Lower leg and lock into position.
5-6.2 Operating Procedures.
a.
S t a r t i n g u n i t .
(1) Plug in power cord .
(2) Move POWER switch to on position.
(3) Check that FWD/REV switch is in FWD position.
(4) Adjust MOTOR SPEED control for satisfactory drying.
b . O p e r a t i n g u n i t .
NOTE
Do not squeegee paper.
Feed into machine dripping wet.
(1) Center material to be dried, and squarely insert between two squeegee
r o l l e r s .
NOTE
Guide large or long material from rear of print dryer. Do not pull.
(2) Remove material from rear of print dryer.
c .
Stopping unit.
Turn off POWER switch.
d. Removing jammed material.
(1) With POWER switch in on position, move FWD/REV switch to REV position.
(2) When material is ejected, move switch to FWD position.
5-6.3 Preparation for Movement.
a.
Unlock leg and fold up.
b . R a i s e l e f t e n d u p w a r d u n t i l p r i n t d r y e r i s v e r t i c a l.
c .
Attach securing strap.
5-11
