Do
RF
(5) Press firmly on extractor tabs to ensure alarm clock board is
seated.
( 6 ) P e r f o r m s e l f - t e s t ( p a r a g r a p h 4 - 6 . 2 ) .
b . D u a l c h a n n e l r e c e
not attempt to remove
i v e r b o a r d ( s l o t 6 / 8 ).
CAUTION
dual channel receiver
c a b l e s .
Damage to-cables or board may occur.
board without disconnecting
( 1)
( 2)
( 3)
( 4)
( 5)
( 6)
Using extractor tabs, pull board out slightly to allow access to
c a b l e s.
Tag and disconnect RF cables from board by grasping brass fitting
w i t h n e e d l e n o s e p l i e r s a n d p u l l i n g s t r a i g h t o f f .
Slide defective dual channel receiver board out of chassis .
Insert new dual channel receiver board into slot and reconnect
c a b l e s .
Press firmly on extractor tabs to seat board.
P e r f o r m s e l f - t e s t ( p a r a g r a p h 4 - 6 . 2 ).
4-210
TM 5-6675-318-14
