TM 5-6675-318-14
Table 4-21. CODE DESCRIPTIONS - Cont
Press the enter (E) key to display and/or enter the UTM scale factor multiplied by
1000. The scale factor is applied to the UTM coordinates. If no value is entered,
999.6 is automatically used.
Scale Factor
Code 110, Display Local Datum Position
NOTE
Datum conversion parameters must be entered using code 100 before code
110 may be used.
Enter code 110 to select the position to be displayed in a local datum. Press the
+/- key to select the desired position as shown by the display.
2D Position Selected
Press the enter (E) key to display the datum shifted latitude in degrees, minutes,
and seconds.
Local Datum Latitude
Press the enter (E) key to display the datum shifted longitude in degrees, minutes,
and seconds.
Local Datum Longitude
4-169
