TM 5-6675-318-14
(15) Press the enter (E) key to erase and display the remaining datum shifted
data (Table 4-18).
b.
UTM coordiantes. The initial procedures for extracting UTM coordinates are
exactly the same as performed for local datum based on WGS-72. Perform step a, (1)
through (10) above (page 4-101) and proceed as follows:
(1) When ZONE is displayed, the computer has automatically entered code 106
(Table 4-19). Enter 0 if the zone is unknown, or enter the zone number upon which
computations are to be based.
(2) If a zone number was entered, display the parameters is accordance with
Table 4-19, then go to step (4).
(3) If a 0 was entered, press the enter (E) key repeatedly until CODE is
displayed.
(4) When CODE is displayed, enter 130 to display UTM coordinates (Table 4-
2 0 ).
(5) When UTM 2D is displayed, press the change sign (+/-) key as many times
as necessary to display the desired position to be converted. The positions
displayed will be: 2D, POINT(3D), TRANSLOC, INPUT, REFERENCE, CONTROL, DR, and
WAYPOINT.
Table 4-18. CODE 110 DISPLAYS FOR LOCAL DATUM POSITION
NOTE
Datum conversion parameters must be entered using code 100 before code
110 may be used.
Enter code 110 to select the position to be displayed in a local datum. Press the
+/- key to select the desired position as shown by the display.
2D Position Selected
Press the enter (E) key to display the datum shifted latitude in degrees, minutes,
and seconds.
Change 2 4-105
