TM 5-6675-318-14
(3)
T h r e a d cleated cable end down through space normally occupied by
pulley 4 and anchor cleated end in bracket.
CAUTION
Pulley will not rotate if washer is not in place.
(4)
Reinstall pulley 4 making sure that washer is reinstalled under
pulley, and thread cable around pulley.
(5)
Bypass pulley 3 and thread cable around pulley 2 to pulley 1.
(6)
T h r e a d cable end adjustment block up into bracket above pulley 1
and install adjust nut finger tight only.
(7)
C h e c k that cable is around pulleys 1 and 2. Then complete stringing
by threading cable around pulley 3.
(8)
A d j u s t tension nut until 5/16 in. (8 mm) of thread is exposed above
nut.
h.
Position pen carriage arm at pen stable end of plotter. Adjust cable
R e f e r to cable tension adjustment procedure
tension for 325 25 g.
i.
Manually exercise pen carriage arm several times along X-axis and
r e c h e c k c a b l e t e n s i o n . R e a d j u s t if necessary. Repeat manual exer-
cising and checking after each adjustment until tension is set to
325 25 g.
Lower upper deck assembly and reinstall rear hood.
j.
3-298
