TM 5-6675-318-14
Table 3-10. PLOTTER PROGRAMMING LANGUAGE - Cont
Statement Identification and Use
Program
Statement
Statement Syntax, Explanation, and Input Instructions
wrt 705, "SM C h a r a c t e r "
w r t - Cont
S y m b o l mode command, "SM", sets symbol mode for use with p l t ,
i p l t , XAX, a n d Y A X s t a t e m e n t s . T h e s e s t a t e m e n t s f u n c t i o n
as described in this table except that specified character is
drawn centered on each plotted point or tic mark. Character
is drawn according to currently selected character set. If
character is not specified, symbol mode is cancelled. All
A S C I I characters from decimal 35 thru 122 can be specified
except the following:
ASCII
Decimal
Value
Character
37
38
39
40
41
47
58
59
60
61
62
63
64
91
92
93
94
95
96
Characters shown above are from set 0. Characters in
other character sets that replace any of these are also not
u s a b l e with symbol mode.
wrt 705, "TL [Up and Right Tic Length
[ , Down and Left Tic Length]]"
T i c l e n g t h c o m m a n d , " T L " , specifies length of tic marks drawn
by axis statements. Tic lengths are specified as percentage
of horizontal and vertical distances between scaling points P1
and P2.
3-97
