TM 5-6675-318-14
Table 3-10. PLOTTER PROGRAMMING LANGUAGE - Cont
Statement Identification and Use
Program
Statement
Statement Syntax, Explanation, and Input Instructions
s c l - Cont
If scaling point P1 is assigned negative (-) coordinates and
P2 is assigned positive coordinates, origin is automatically
If both sets of coordinates for
set at center of plot area.
points are positive, origin will be off of paper in lower left
For two negative sets of
corner as shown in illustration.
coordinates, origin is off of paper in upper right corner.
This scale corresponds to a centimeter unit of the platen area with the origin (0,0) at
the current location of P1. Since the scale corresponds to a unit measure (centimeters),
the P2 scaling point is not referenced.
Scale is automatically set when plotter is initialized or scl
statement without parameters is input. Origin is set at P1
and platen is divided into units 1 cm in length.
Coordinates of P1 and P2 in internal units of plotter are:
P 1 (520, 380) and P2 (15720, 10380)
S e n d s all previous parameters sent in
PLOTTER CLEAR.
pclr
programming statement to their default values, with following
exceptions:
s c l and psc parameters
P1 and P2 remain unchanged.
Pen does not move but point raises.
Syntax:
p c l r (No Parameters)
3-79
