TM 5-6675-318-14
NOTE
O p e r a t i o n of the HP-IB Interface ROM is explained in the following
paragraphs in terms of the type of function being performed.
(b) Monitoring signal lines.
I n order to determine its mode of opera-
tion, the HP-IB Interface ROM has a processor in the control logic circuit that
monitors the signal lines from the computer and the plotter.
(c) Monitoring of the computer is accomplished via a calculator flag
( C F L A G ) signal from the computer command register circuit, When the computer
requests an input/output (I/O) operation from the HP-IB Interface, the CFLAG signal
i s s e n t t r u e . A true CFLAG signal induces the processor in the control logic
circuit to send instructions to other circuits to decode and execute the requested
I/O operation.
(d) To monitor the plotter for an I/O operation request, the processor
in the control logic circuit periodically samples signals on the control lines and
If the state of these signals indicates an operation is requested,
transfer lines.
the processor issues appropriate instructions.
(3) Select code decoder circuit determines initially when the HP-IB Inter-
f a c e ROM is being addressed by the computer.
A select code switch in the circuit
e s t a b l i s h e s a unique select code for the HP-IB Interface ROM, which will only
respond when an identical code is sent on peripheral address lines PA thru PA3.
The circuit sends calculator flag (CFLAG) signal low to indicate its presence and
readiness to the computer and sends status (STS) line low to tell the computer that
no error conditions exist. The circuit responds to the receipt of a correct address
code by looking for an I/O command via the I/O register decoder circuit.
(4) I/O register decoder circuit contains a set of gates that interpret an
I / O command from the computer.
A direction of transfer (DOUT) signal indicates to
the circuit whether a transfer is an input or output operation from the computer,
i.e., whether data will be transferred to or from the HP-IB Interface.
If a data
transfer to the HP-IB Interface is indicated, the circuit latches any data on the
I/O data lines IOD thru IOD7 into the output register of the I/O data register
T h e IOSB signal also induces the
circuit with an I/O strobe pulse (IOSB) signal.
l a t c h i n g of any coded signals on the DOUT, IC1, and IC2 lines into the computer
I f the HP-IB Interface ROM were transferring data to the
command register circuit.
computer (from the HP-IB Interface), the circuit would operate in the opposite
D a t a would be latched onto the computer
direction upon receipt of the IOSB signal.
d a t a lines IOD thru IOD7.
NOTE
Data cannot be inputted to the computer when it is conducting an interrupt
The INT signal is low for an interrupt poll.
poll.
3-10
