TM 5-6675-317-14
f. Apply tape, holding it taut, and apply it perpendicular to panel skin.
Do not apply with rolling motion either end-to-end or center-to-ends.
Do not rub each strip in place individually. Apply all strips lightly
with proper overlap and rub into place.
g.
If necessary, damaged tape can be replaced; however, it should be
removed with careful peeling motion to avoid damage to sealant. If
sealant also peels back, new sealant should be applied. Complete
removal of old sealant is not necessary.
Permanent repair by direct
support, or higher category of maintenance, should be made as soon as
possible.
1-16.14 Replace Tiedown Socket.
MOS :
83FJ6, Reproduction Equipment Repairer
TOOLS:
Cross Tip Screwdriver
Flat Tip Screwdriver
SUPPLIES:
Tiedown Socket
a. Remove screws from tiedown socket.
b.
Pry defective socket from floor.
c. Install new tiedown socket.
Rotate new tiedown socket enough to avoid
installing screws in old screw holes.
d.
Reinstall screws.
1-81
