TM 5-6675-317-14
Section III
7-8. LUBRICATION INSTRUCTIONS.
OPERATOR MAINTENANCE
This equipment does not require lubrication.
7-9. TROUBLESHOOTING PROCEDURES. There are no operator troubleshooting procedures
assigned for this equipment.
7-10. MAINTENANCE PROCEDURES.
a.
This section contains instructions covering operator maintenance functions
for the furniture and cabinets.
Personnel required are listed only if the task
requires more than one.
b.
After completing each maintenance procedure, perform operational check to be
sure that equipment is properly functioning.
7-10.1 Inspect Cabinets and Furniture.
Inspect furniture and cabinets for
structural damage, rust, and proper operation of all latches, hinges, drawer slides,
and adjustment mechanisms.
Section IV
ORGANIZATIONAL MAINTENANCE
7-11.
7-12.
MENT
LUBRICATION INSTRUCTIONS. This equipment does not
REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT,
(TMDE); AND SUPPORT EQUIPMENT
7-12.1 Common Tools and Equipment. For author
refer to the Modified Table of Organization and
unit.
require lubrication.
AND DIAGNOSTIC EQUIP-
zed common tools and equipment,
Equipment (MTOE) applicable to your
7-12.2 Special Tools; Test, Measurement, and Diagnostic Equipment; and Support
Equipment.
Special Tools, TMDE, and Support Equipment is listed in the applicable
repair parts and special tools list and in Appendix B of this manual.
7-12.3 Repair Parts.
Repair parts are listed and illustrated in the Repair Parts
and Special Tools List, TM 5-6675-317-24P covering organizational maintenance for
this equipment.
7-3
