TM 5-6675-317-14
Table 2-3. ORGANIZATIONAL TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
3.
TABLE DOES NOT LOCK - Cont
Step 4.
Check for defective tilt locking block.
(a) If good, proceed to step 5.
(b) If defective, replace (paragraph 2-16.6).
Step 5.
Check for defective tilt locking plate.
If defective, replace (paragraph 2-16.6).
2-16. MAINTENANCE PROCEDURES.
This section contains instructions covering organizational maintenance
functions for the drafting, scribing/tracing table.
Personnel required are listed
only if the task requires more than one.
b.
After completing each maintenance procedure, perform operational check to
be sure that equipment is properly functioning.
INDEX
PROCEDURES
PARAGRAPH
Replace Power Switch . . . . . . . . . . . . . . . . . . . . . . . . . 2-16.1
Replace Power Cord . . . . . . . . . . . . . . . . . . . . . . . . . 2-16.2
Replace Receptacle . . . . . . . . . . . . . . . . l . . . . l . . l 2-16.3
Replace Lamp Ballast . . . . . . . . . . . . . . . l . . l . . l l l 2-16.4
Replace Tube/Starter . . . . . . . . . . . . . . . . . . . . . . . . . 2-16.5
Repair Tilt Lock Assembly.. . . . . . . . . . . . . . . . . . . . . . 2-16.6
Replace Pillow Block Assembly . . . . . . . . . . . . . . . . . . . . . 2-16.7
Remove/Install Drafting, Scribing/Tracing Table . . . . . . . . . . . . 2-16.8
2-17
