TM 5-6675-316-14
NOTE
Preset value is entered by entering value of X-coordinate first and then
Y-coordinate.
(a) Press 7 and X on keyboard to enter value of X-coordinate.
(b) If preset value is negative number, press negative key. Key in number
using P key to enter any decimal points.
(c) Press X again to terminate X entry. Check X line of XY display to
be sure correct number is displayed.
(d) Press 7 and Y on keyboard to enter value of Y-coordinate.
(e) If value to be entered is negative number, press negative key. Key in
preset value using P key to enter any decimal point.
,
(f) Press Y again to terminate Y entry. Check Y line of XY display to
be sure correct number is displayed.
Using manual drafting tools.
For procedures concerning use of manual draf-
ting tools, including mounting, installation of attachments, and operating adjust-
ments, refer to applicable tool and procedure in Table 3-4.
3-65
