8-76
TM 5-6675-316-14
i.
j.
k.
l.
m.
n.
o.
Remove
block.
cable wires from ground terminal, HEAT ON switch, and terminal
Pull cable out of wax coater through hole in rear panel.
Feed new cable through hole in rear panel and through cable holding
brackets.
Strip insulation from ends of wires and crimp on terminal connectors.
Attach wires to ground, HEAT ON switch, and terminal block per wiring
schematic.
Tighten cable holding brackets.
Reinstall right side panel.
CAUTION
8-20.10
When moving inner panel, keep rear of machine lifted so it does not catch on
pilot light or damage to light may result.
P.
Reinstall inner panel.
q.
Reinstall top deck cover and top roller cover.
Rep
lace Heating Element.
MOS: 83FJ6, Reproduction Equipment Repairer
TOOLS: Flat Tip Screwdriver
Cross Tip Screwdriver
Wire Stripper/Crimper
Heat Shrink Gun
SUPPLIES: Heating Element
WARNING
Serious injury may occur if internal components are touched when heat is
on.
Remove heat source and allow to cool, or wear protective clothing
before servicing.
Death or serious injury may occur from electrical shock unless power
cord is unplugged before servicing.
a.
Unplug power cord.
b. Remove top deck cover and top roller cover.
