TM 5-6675-316-14
u.
Note thermometer reading.
If it is not between 175° and 178° F, adjust
as follows:
(1) If temperature is below 175° F.
(a) Hold shaft of thermostat steady with pliers.
(b) Squeeze spring lever and move to the left a few degrees.
(2) If temperature indicated is above 128° F.
(a) Hold shaft steady with pliers.
(b) Squeeze lever spring and move to the right a few degrees.
(3) After adjusting thermostat lever:
(a) Move lever to position in normal fashion.
(b) Allow time for temperature to adjust (approximately ten
minutes).
(c) Note thermometer reading.
If too low or too high, repeat
steps as necessary.
CAUTION
When moving inner panel, keep rear of machine lifted so it does not catch on
pilot light or damage to light may result.
q.
Reinstall inner panel by sliding it back into retaining clips.
r.
Reinstall top deck cover and top roller cover.
s.
Turn MAIN switch OFF if wax coater is not to be used.
8-63
