TM 5-6675-316-14
d. Grasp edges and pull right side panel away from wax coater.
e .
Loosen four screws holding main drive motor.
f. Check belt for signs of damage. If not damaged,
loose.
If loose, perform the following steps:
check to see if it is
(1) Grasp the main gear and slide it and motor away from secondary gear
until belt pulls taut.
(2) Go to step j.
9.
Grasp main drive gear and slide toward secondary gear (rear).
h.
Remove defective belt.
Slip new belt on gears.
NOTE
Be sure that teeth of belt lie in grooves of gears.
i.
With one hand, grasp main gear and slide it away from secondary gear
until belt is taut.
NOTE
Do not make belt so tight that sudden stopping of secondary gear will snap
or stretch belt.
8-61
