CAUTION
Removal of five socket head screws located
result
c.
d.
TM 5-6675-316-14
closest to glass surface may
in damage to equipment.
Remove nine socket head screws and left panel, but do not remove five
socket head screws indicated in CAUTION and illustration.
Pull cabinet assembly lock release and swing cabinet assembly out so
that it is not under table.
NOTE
Tilt lock plates are not interchangeable and must be replaced in same
positions.
e.
Remove upper screws, nuts, and washers from defective tilt lock plate.
f. Tilt table top as necessary and remove defective tilt lock plate by
removing lower screws, nuts, and washers.
9.
Install new tilt lock plate and secure with washers, nuts, and screws.
h. Check position of tilt lock plate and readjust if required.
i.
Remove defective limit control plate by removing screws, washers,
.
j.
Install new limit control plate. Secure with nuts, washers, and
screws.
k. Reinstall left panel and secure with nine socket head screws.
NOTE
Use care in disassembly of safety stop to prevent spring from falling inside
frame.
l.
Remove defective safety stop by removing nut, lockwasher, sleeve,
and nuts.
spring, spacer, and screw.
m.
Install new safety stop. Secure with screw
lockwasher, and nut.
n.
Swing cabinet assembly to its normal posit
o.
Plug in power cord.
9
spacer, spring, sleeve,
on under table.
7-31
