TM 5-6675-316-14
4-16. MAINTENANCE PROCEDURES.
a. This section contains instructions covering organizational maintenance functions for the split-stage light
table. Personnel required are listed only if the task requires more than one.
b. After completing each maintenance procedure, perform operational check to be sure that equipment is
properly functioning.
PROCEDURE
Replace ON/OFF
INDEX
PARAGRAPH
Switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...4-16.1
Replace Grid intensity Control Potentiometer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...4-16.2
Replace Main Power Switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...4-16.3
Replace Brush . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...4-16.4
Remove/install Split-Stage Light Table. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...4-16.5
4-16.1 Replace ON/OFF Switch.
MOS: 41 B, Topographic Instrument Repair Specialist
TOOLS: 7/64 in. Hex Head Key Wrench
7/1 6 in. Open End Wrench
Soldering Gun
SUPPLIES: Toggle Switch
Solder (Item 23, Appendix E)
WARNING
Death or serious injury may occur from electrical shock unless power cord is
unplugged before servicing equipment.
4-44
Change 1
