TM 5-6675-316-14
NOTE
20 degrees rotation of mechanical timing equals 0.005 in. at 36 point.
(2) If font 4 "Z" is LOW, turn mechanical timing screw to the left.
(3) If font 4 "Z" is HIGH, turn mechanical timing screw to the right.
If baselines varies between characters of the same font and size,
e.
adjust as follows:
(1) Adjust scanning carriage linear bearings to zero clearance.
(2) Tighten wayrod hold down clamps.
f. If baseline varies between characters of different point size, adjust
variator lens vertically.
(1) Remove center panel.
2-324
