TM 5-6675-316-14
Table 2-6. DIRECT/GENERAL SUPPORT TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
CHARACTER DENSITY VARIES WITH POINT SIZE.
3.
Check flash intensity reference and large size adjustment.
Adjust flash intensity and 1arge size (paragraph 2-20.23).
4.
FOCUS IS GENERALLY POOR.
Check flash intensity reference and large size adjustment.
Step 1.
(a) If adjustment is correct, proceed to step 2.
(b) If not correct, perform flash intensity and large size
adjustment (paragraph 2-20.23).
Check optical focus switches on carriage escapement board against
Step 2.
punch chart inside top left panel.
(a) If switch settings are correct, proceed to step 3.
(b) If not correct, correct switch settings.
Check flash power supply reference and large size adjustments.
Step 3.
Adjust flash power supply reference and large size (paragraph
5. NO POWER.
Check output of constant voltage transformer.
Step 1.
(a) If present, repair wiring between TB2 and constant voltage
(b) If not present, proceed to step 2.
Check input of constant voltage transformer.
Step 2.
(a) If not present, proceed to step 3.
(b) If present, replace constant voltage transformer (paragraph
2-191
