TM 5-6675-315-14
3-16. MAINTENANCE PROCEDURES.
a.
This section contains instructions covering organizational maintenance functions for the cabinets and
furniture. Personnel required are listed only if the task requires more than one.
b.
After completing each maintenance procedure, perform operational check to be sure that equipment is
properly functioning.
INDEX
PROCEDURE
PARAGRAPH
Replace Door Hinge (Piano Hinge) ...............................................................................................
3-16.1
Replace Door Latch (Wall Storage Cabinet) . ...............................................................................
3-16.2
Remove/Install Storage Shelves . ................................................................................................
3-16.3
Remove/Install Office Table . .......................................................................................................
3-16.4
Remove/Install Wall Storage Cabinet . .........................................................................................
3-16.5
3-16.1
Replace Door Hinge (Piano Hinge).
MOS: 83FJ6, Reproduction Equipment Repairer
TOOLS:
1/4 in. Electric Drill
5/32 in. Twist Drill
Pop Rivet Gun
SUPPLIES:
Storage Cabinet Hinge
5/32 in. Pop Rivets
8-32 x 1/2 in. Screws (4 required)
8-32 Nuts (4 required)
a.
Drill out rivets holding hinge to cabinet and remove hinge.
b.
Install new hinge and temporarily secure with four screws and nuts.
c.
Close and latch cabinet door and install 12 pop rivets.
d.
Remove temporarily installed screws and nuts, and install remaining pop rivets.
35
