TM 5-6675-315-14
e.
Back tensioning rod away from motor.
f.
Loosen two motor mounting bolts.
g.
Remove top left mechanism cover side panel to gain access to inner motor mounting bolts and loosen remaining
two bolts.
h.
Slide motor toward cutter until V-belts are loose enough to slide off pulley.
NOTE
Replace all V-belts.
i.
Replace defective V-belts. Be sure that centrifugal switch FL rests on top of all V-belts.
j.
Slide motor away from cutter until V-belts appear tight. Be sure that axis of motor forms 90 degree angle to V-
belts.
NOTE
Misalignment of motor would cause belts to bind.
k.
Tighten all four bolts hand tight.
2-95