TM 5-6675-315-14
f.
Remove mounting bolts and washers.
g.
Slide out air conditioner until other lifting handles are free. Attach
sling to handles.
h.
Raise defective air conditioner/heater with hoist until unit is free
from brackets and van body.
i.
Place air conditioner/heater on flat-bed truck or pallet.
WARNING
Dry cleaning solvent, P-D-680, used to clean parts is potentially dangerous to personnel and property.
Avoid repeated and prolonged skin contact. Wear solvent impermeable gloves and eye/face protective
equipment when using solvent. Do not use near open flame or excessive heat. Flash point of solvent is
100° to 138° (38°C to 59°C).
j.
Clean sealant from opening using dry cleaning solvent P-D-680.
k.
Remove damaged gasket and replace with new gasket.
l
Raise air conditioner/heater until it rests on air conditioner/heater brackets.
m. Remove two sling hooks as unit is eased into hole until grille touches
duct.
n.
Remove remaining sling.
o.
Reinstall washers and mounting bolts.
p.
Reconnect drain lines.
q.
Reinstall screws securing air conditioner/heater mounting to section wall. Reinstall screw, washer, and nut to
each
corner of mounting.
r.
Reinstall screws securing air duct to air conditioner/heater.
s.
Reconnect or plug in power cord. Turn on air conditioner/heater circuit
breaker.
1-102
