TM 5-6675-314-14
Section Ill OPERATOR MAINTENANCE
1-8. LUBRICATION INSTRUCTIONS.
a.
Lubrication instructions for the Storage and Distribution Section are con-
tained in LO 5-6675-314-12, Lubrication Order, Storage and Distribution Section,
Topographic Support System.
The intervals and manhours specified in the Lubrication
Order are based on normal operations.
During inactive periods, lubrication periods
may be extended with adequate preservation.
b. Topographic equipment and all optical equipment require special care in
l u b r i c a t i o n.
When a specified lubricant is called for, substitutions are not au-
t h o r i z e d.
Minimum amounts of lubricant are to be used and all excess lubricant is
to be immediately removed.
Spray lubricants must not be used in the vicinity of
optical equipment unless optics are completely Protected. No lubricant is to be
applied unless a thorough cleaning is conducted” first to remove
s i v e m a t e r i a l .
c .
Be sure that you refer to the appropriate chapter before
stored after use. that the temperature has stabilized. and that
after use is accomplished.
1-9. TROUBLESHOOTING PROCEDURES.
a.
The table lists the common malfunctions
or maintenance of the Storage and Distribution
d i r t , d u s t , o r a b r a -
any equipment is
r e q u i r e d l u b r i c a t i on
which you may find during operation
Section, or its components. You
should perform the test/inspections and corrective actions in the order listed.
b. This manual cannot list all malfunctions that may occur, nor all test or
inspections and corrective actions.
I f a m a l f u n c t i o n i s n o t l i s t e d o r i s n ot
corrected by listed corrective actions, notify your supervisor .
1-42
