Section IV ORGANIZATIONAL
TM 5-6675-313-14
MAINTENANCE
2-11.
LUBRICATION INSTRUCTIONS.
2-11.1 Pillow Block Fittings. After replacement. apply ball and roller bearing
grease (Item 9, Appendix E) to pillow blocks.
a.
Apply grease sparingly using grease gun.
b.
Wipe grease fittings clean after application.
2-12. REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC
EQUIPMENT (TMDE); AND SUPPORT EQUIPMENT.
2-12.1 Common Tools and Equipment.
For authorized common tools and equipment,
refer to the Modified Table of Organization and Equipment (MTOE) applicable to your
unit.
2-12.2 Special Tools; Test, Measurement, and Diagnostic Equipment; and Support
Equipment.
Special Tools, TMDE, and Support Equipment is listed in the applicable
repair parts and special tools list and in Appendix B of this manual.
2-12.3 Repair Parts.
Repair parts are listed and illustrated in the Repair Parts
and Special Tools List, TM 5-6675-313-24P covering organizational maintenance for
this equipment.
2-13. SERVICE
ceived mounted
UPON RECEIPT.
in the section
The drafting, scribing/tracing table may be re-
or in a shipping crate.
2-13.1 Checking Unpacked Equipment.
a.
Inspect the equipment for damage incurred during shipment. If equipment has
been damaged, report the damage on DD Form 6, Packing improvement Report.
b.
Check the equipment against the packing list to see if the shipment
complete.
Report all discrepancies in accordance with the instructions of
DA Pam 738-750.
c.
Check to see whether the equipment has been
2-14. ORGANIZATIONAL PREVENTIVE MAINTENANCE
are no organizational PMCS procedures assigned for
modified.
CHECKS AND SERVICES.
this equipment.
is
There
2-15
