TM 5-6675-313-14
Section III OPERATOR MAINTENANCE
2-8. LUBRICATION INSTRUCTIONS.
NOTE
These lubrication instructions are mandatory.
2-8.1 Pillow Block Fittings.
Apply ball and roller bearing grease (Item 9,
Appendix E) to both pillow b locks annually.
a. Apply grease sparingly using grease gun.
b.
Wipe grease fittings clean after application.
2-9. TROUBLESHOOTING PROCEDURES.
a.
The table lists the common malfunctions which you may find during operation
or maintenance of the drafting, scribing/tracing table, or its components.
You
should perform the test/inspections and corrective actions in the order listed.
b.
This manual cannot list all malfunctions that may occur, nor all test or
inspections and corrective actions.
If a malfunction is not listed or is not
corrected by listed corrective actions, notify your supervisor.
2-12
