TM 5-6675-302-14&P
Table 3-1. Operator/Crew Preventive Maintenance Checks and Services
B-Before
A-After
M--Monthly
D-During
W-Weekly
Procedures
Item
Interval
Item To Be
Check for and have repaired
Equipment Is Not
No.
B D A W M
Inspected
or adjusted as necessary
Ready/Available If
1
l
Accessory case
Check for serviceability and presence of
components.
2
l
Battery box
Check for serviceability and presence of
Faulty batteries
components. Check batteries and wiring
for serviceability. Check rheostat for
tight and clean connections and proper
operation.
3
l
Head lamp
Check for serviceability and operation.
Bad lamp
4
l
Tripod
Check for serviceability.
5
l
All components
Check for proper function, alignment,
adjustment, and calibration.
b. Interval Columns. The columns headed B, D,
/Available Column. This column will contain the
A, W, and M, will contain a dot (.) opposite the ap-
criteria which will cause the equipment to be
propriate check indicating it is to be performed
classified as Not Ready/Available because of in-
Before, During, After, Weekly or Monthly.
ability to perform its primary mission.
c. Item to be Inspected Column. The items
listed in this column are divided into groups and
NOTE
identifies the items to be inspected.
If the equipment must be kept in con-
d. Procedures Column. This column contains a
tinuous operation, check and service on-
brief description of the procedure by which the
ly those items that can be checked and
check is to be performed.
serviced without disturbing operation.
e.
3-6.
Make the complete checks and services
Equipment will be Reported Not Ready
when the equipment can be shutdown.
Section IV. OPERATORS MAINTENANCE
General. This section describes maintenance
c. Install serviceable lamps in the illumination
functions which the operator must perform on
components of the target set.
3-7. Lamps,
Illumination Assembly (Model
242406), or Screw-In Lamp Assembly (Model
USATS-79), Replacement.
a. Remove and replace defective lamp from the
illumination assembly and reflector as illustrated
in figure 3-1 for model 242406, or from screw-in
lamp assembly and reflector as illustrated in
figure 3-2 for model USATS-79.
b. Clean the reflector inner surface with a soft
clean cloth.
assembly (model 242406), or screw-in lamp
assembly (model USATS-79).
3-8. Lamp, Eyepiece Adapter, Replacement.
a. Remove and replace defective lamp from the
eyepiece adapter as illustrated in figure 3-3.
b. Install serviceable lamp in eyepiece adapter.
3-9. Lamp, Handlamp Assembly, Replacement.
a. Remove and replace defective lamp from the
handlamp assembly as illustrated in figure 3-4 for
model 242406, or figure 3-5 for model USATS-79.
3-2