ARMY TM 5-6675-238-14
MARINE CORPS TM 08839A-14/1
CHAPTER 2
SERVICE UPON RECEIPT AND INSTALLATION
Section I. SITE AND SHELTER REQUIREMENTS
2-1 General. This section describes site and shelter
Number 5 or a permanent installation that has 115-
requirements for the PADS test set.
volts, 50-to 400-Hertz power, can be utilized for
PADS test set operation. The buffer unit is designed to
2-2. Site and Shelter Requirements. The PADS test set
operate in the ambient environment conditions existing
is designed for operation in a sheltered maintenance
outside the maintenance shop for IMU calibration.
shop. The Semitrailer-Mounted Electronic Shop Set
Section Il. SERVICE UPON RECEIPT OF MATERIEL
2-3. Unpacking Instmctions.
The PADS test set contains delicate elec-
tronic equipment. Be extremely careful
when removing each item from container,
a. The items comprising the PADS test set are
packaged in three containers: One container for the
SPU and transit case; a second container for the tape
reader and transit case; and a third container for the
buffer unit, cables, card extractors, tape reel, and transit
case, See figure 2-1 for a typical packaging diagram.
b. Unpack items from containers as shown in figure
2-1.
c. Press transit case pressure relief valve.
d. Remove equipment from transit cases.
2-4. Checking Unpacked Equipment.
a. Inspect the equipment for damage incurred dur-
ing shipment, If the equipment has been damaged,
report the damage on DD Form 6 (Packaging Improve-
ment Report).
b. Check the equipment against the component
listing in appendix B and the packing slip to see if the
shipment is complete. Report all discrepancies in ac-
cordance with paragraph 1-2. The equipment should be
placed in service even though a minor assembly or part
that does not affect proper functioning is missing.
c. Check to see whether the equipment has been
modified. (Equipment which has been modified will
have the MWO number on the front panel, near the
nomenclature plate.) Check also to see whether all
currently applicable MWO’S have been applied. (Cur-
rent MWO’S applicable to the equipment are listed in
DA PAM 310-7).
d. For dimensions, weights, and volume of pack-
aged items, see SB 700-20.
2-1
