ARMY TM 5-6675-238-14
MARINE CORPS TM 08839A-14/1
APPENDIX B
COMPONENTS OF END ITEM LIST
Section I. INTRODUCTION
B-1. Scope. This appendix lists integral components of
and basic issue items for the PADS test set to help you
inventory items required for safe and efficient operation.
B-2. General. The Components of End Item List is
divided into the following sections:
a. Section II. Integral Components of the End
Item. These items, when assembled, comprise the PADS
test set and must accompany it whenever it is transfer-
red or turned in. These illustrations will help you
identify these items.
b. Section III. Basic Issue Items. These are mini-
mum essential items required to place the PADS test
set in operation, to operate it, and to perform emer-
gency repairs. Although shipped separately packed, they
must accompany the PADS test set during operation
and whenever it is transferred between accountable
officers. The illustrations will assist you with hard-to-
identify items. This manual is your authority to requisi-
tion replacement BII, based on Table(s) of Operation
and Equipment (TOE)/Modification Table of Organiza-
tion and Equipment (MTOE) authorization of the end
item.
B-3. Explanation of Columns.
a. Illustration. This column is divided as follows:
(1) Figure number. Indicates the figure number of
the illustration on which the item is shown (if applica-
ble).
(2) Item number. The number used to identify
item called out in the illustration.
b. National Stock Number (NSN). Indicates the
National stock number assigned to the item and which
will be used for requisitioning.
c. Part Number (PIN). Indicates the primary num-
ber used by the manufacturer, which controls the design
and characteristics of the item by means of its engineer-
ing drawings, specifications, standards, and inspection
requirements to identify an item or range of items.
d. Description.
Indicates the Federal item name
and, if required, a minimum description to identfy the
item.
e. Location. The physical location of each item
listed is given in this column. The lists are designed to
inventory all items in one area of the major item before
moving on to an adjacent area.
f. Usable on Code. USABLE ON codes are in-
cluded to help you identify which component items are
used on the different models. Identification of the codes
used in these lists are:
Code
Used on
DED
AN/USM-427
g.
Quantity Required (Qty Reqd). This column lists
the quantity of each item required for a complete major
item.
h. Quantity. This column is left blank for use dur-
ing inventory. Under the Rcvd column, list the quantity
you actually receive on your major item. The Date
columns are for your use when you inventory the major
item at a later date, such as for shipment to another
site.
B-1