TM 5-3610-286-20
2-94.
Auxiliary Control Boxes.
This task covers:
a. Test
b. Replace
c. Repair
INITIAL SETUP
Tools
General Safety Instructions
0.046 x 0.313 x 6 in. flat-tip screwdriver
WARNING
No. 3 x 6 in. cross-tip screwdriver
Hazardous electrical voltages exist within
Additional Personnel Requirement
printing press. Do not connector discon-
nect any electrical components while power
Electrician MOS 35E20
is on. Death, serious electrical shock, or
burns may result.
a. Test. Malfunctioning switches, lamps and the sheet counter can be located by use of
troubleshooting procedures given in table 2-5.
b. Replace.
(1) Press unit control boxes. (figure 2-273)
(a)
(b)
(c)
(d)
(e)
(f)
(9)
(h)
2-540
Remove four cross-head screws (1) and washers (2).
Separate auxiliary feeder control with sheet counter panel (3) from box (4).
Tag and remove leads to all panel components and remove panel (3).
Remove four cross-head screws (5) and control box (4).
Remove four slotted screws (6) and washers (7).
Tag and remove leads to all panel components and remove auxiliary press unit/safety
stop control panel (8).
Install tagged leads to all panel components and install auxiliary press unit/safety stop
control panel (8). Remove tags.
Install four washers (7) and four slotted screws (6).
